How to apply lace front wigs?
There are two ways to apply lace front wigs; one is using double-sided tape another is liquid adhesive to hold the wig down in place. Some wig retailers sell adhesive or the tape along with the hair wigs.If it is your first time to wear lace wigs, our advice is wearing it with the help of hairdresseer in salon.
If you are using liquid adhesive, first put the lace wig over your head. Pin back the hair on the wig in front so that it doesn’t get glued on to your forehead. Put a very little bit of adhesive on a small portion of the lace front wig. Also, make sure that your natural hair is pinned back and out of the way. You can decide to cut off your baby hair or choose to keep it so that it appears from under the wig depending on what hair style you intend to have. Apply pressure on the part of the lace front wig where you applied adhesive. If its good adhesive that you have used, it should take about five seconds for it to stay in place. Next, move on to the next section inch by inch till you have covered the entire area.
If you have decided to use double-sided tape, cut it into strips of three inches. The tape should about 3.8 inches wide. Put the first strip on an area where it connects to the lace front wig. You must ensure that the tape is attached on the front hairline towards the edge of the lace. Put more strips of tape at the perimeter of the lace till you have covered the whole front portion of the lace wig from one side to another. Also make sure that there are gaps between the tapes. This should assist in keeping the wig in place and show a natural hairline at the same time.






